Maxibright Focus 315w CDM full fixture grow Light Kit 

The Maxibright focus kit is available with 2 types of reflector The (remote) which comes with a 5m iec connection allowing you ro replace the ballast up to 5 meters away from the reflector/lamp, the focus connect is designed for the ballast to be connected on to the back of the reflecter enabling for a full fixture style kit. T full fixture grow light kit is the next generation of lighting to help get the most out of your grow room by improving overall plant health, along with increasing yield and improving taste/aromas of fruits at harvest. 

Using Philips CDM (Ceramic Discharge Metal-Halide) grow lamps, they emit an intense and bright full light spectrum with high PAR levels that will easily beat any 400w HPS, while using just 315w. There are also 2 choices of lamp available; The Philips MasterColour 942 Daylight that has an increased blue spectrum for improved vegetative growth or the Philips GreenPower 930 Elite Agro with an increased red and fuller light spectrum to help boost yields throughout fruiting. 

About the Focus reflector

Designed to be powered by the maxibright daylight 315w cdm ballast but can be used with other brands, The new maxibright 315w focus remote reflector is designed to externally plug in to any 315w cdm ballast and the maxibright focus "connect" is designed for the maxibright 315w daylight ballast to connect on to the back of it making it a ull fixture grow light, the maxibright focus reflector is designed for an optimum 1.2 x 1.2 growing area.

21.46% more more  focused light compared to standard 315w reflectors.
comes complete with 5m iec cable.

Suitable only for 315w cdm lamps.

Dimensions 300mm x 300mm x 110mm

To complete the lighting system, the Maxibright Daylight 315w digital ballast features soft-start technology, allowing the lamp to gently start up on a lower current to avoid any electrical tripping. This helps to extend the lifetime of bulbs. In addition, the Daylight ballast includes end-of-lamp-life detection, short-circuit and thermal protection, auto-reset and dynamic frequency control. The ballast is also lightweight and runs silently. 

Includes
The Maxibright Daylight 315w kit includes: 
1x Maxibright Daylight 315w Digital Ballast 
1x Maxibright focus Reflector
1x Philips Daylight or Elite Agro Grow Lamp

Directions of use: 
The reflector should be positioned at the required height dependant on your set-up, ensuring it isn't too close to the tops of your plants. Always use a dry cloth when holding the lamp and placing it into the lamp holder. This helps to avoid getting any contaminants on the glass from your fingers so you do not unintentionally cause damage to the lamp.
Until your CDM lamps have achieved at least 10 hours of use, they should not be switched off for at least 2 minutes after being switched on. If this does happen, you must leave the lamp switched off for at least 1 hour before switching it back on again. If not, you could damage the lamp, leading to future start up problems.
Also note that the wattage of your ballast must match the wattage of the lamp that you are using otherwise you will damage the equipment. The ballast must never be covered, and should be placed in a well-ventilated area on a flat surface, away from any carpet.